How Tow to install wallpaperÂ
Initial Touch:
Wallpapers look perfect on the walls when the surface is smooth, clean with no unevenness and moisture on it. Old scrapped-out paints or wallpapers must be removed. Primers are preferred if there is a huge impact of the previous paint on the walls. How to install wallpaperÂ
Creating the Mixture:
- A bucket is used for creating the mixture.
- The package which contains the Adhesive content is poured into the bucket and Four liters of cold water is mixed into it
- The content is mixed for 30 seconds and again after 3 minutes, it is stirred.
- After 15 minutes, a final stir is given to the mixture and it is ready to use.
Steps for Application of the Wallpapers:
This manual describes the essential steps to apply the wallpaper rolls. Please check this manual to understand how to apply our custom-sized murals.
The Non-Woven Mixture
Ensure that the wallpaper rolls are in proper condition without any defect or damage. The non-woven mixture is used as an adhesive to apply the wallpapers.
Length of the Wallpaper
The wallpapers are installed from left to right and it is initiated by applying from the left corner of your wall. The sheets should be hung from one edge to the other without causing any overlapping. Please ensure the first length of the wallpaper is vertically straight.
Remove the Air Bubbles
After pasting one sheet make sure you remove the air bubbles if any. Removing the air bubbles gives the wallpapers a proper smooth texture along with a finished look.
Applying the Paste
Apply the non-woven mixture onto the wall and secure every inch of the wall is covered with the paste. If any of the spots are missed out, it will create air bubbles in the wallpaper sheets. The wallpapers need to be pasted in one area and should cover one and a half lengths at one go.
Repeat the process
Ensure that the wallpaper rolls are in proper condition without any defect or damage. The non-woven mixture is used as an adhesive to apply the wallpapers.
Cleaning the Surface
After the application, the entire wallpapers need to be cleaned. While applying make certain that the non-woven paste doesn’t damage the front of the wallpaper. If there is a situation like this, the excess paste should be removed immediately using a wet wallpaper sponge.
Applying the Paste
Once the application of the wallpaper is complete, remove the extra portions of the sheets from the ceiling and floor.
For removing the excess parts use a sharp knife preferably an X-ACTO knife. In the end, the room should be left ventilated and should be kept at a normal temperature for 24 hours to allow the wallpaper to dry easily.
Wallpapers look perfect on the walls when the surface is smooth, clean with no unevenness and moisture on it.
The wallpaper sheets are directly pulled towards the ceiling at the time of application. They should hang straight and forcing the strips together should be avoided. If there is any problem during the application, it is better to remove the strips and reattach the sheets again if the edges do not meet.
More News & Information
Boho Decor: How To Make Your Rooms Into Bohemian Masterpieces
Boho decors have taken the center stage in the recent few years when it…
Read More5 Bedroom Ideas That Are a Must-Have For Millennials
Millennials have entered that phase in their lives where words like house plans, EMI’s…
Read MoreRetro-Themed Ideas For a Vintage Home Aesthetic
Introduction In the last decade, Retro themed designs have been among the most trending…
Read More4 Traveller Home Ideas That would Fill Your Rooms With Wanderlust
Introduction These traveller home ideas are for those of us who have the feeling…
Read More